I'm sure I just don't know what to ask for...
Is there an easy way to put an 'end of view' line marker on your drawing? Similar to a line break, but it's understood that the modeled part would keep going even though it's not shown?
SW Premium 2012
64 bit SP1.0
Intel Xeon X5650 E5-1603 0 @ 2.80 GHz
8.0 GB of RAM
Is there an easy way to put an 'end of view' line marker on your drawing? Similar to a line break, but it's understood that the modeled part would keep going even though it's not shown?
SW Premium 2012
64 bit SP1.0
Intel Xeon X5650 E5-1603 0 @ 2.80 GHz
8.0 GB of RAM