Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Width before length

Status
Not open for further replies.

archark1

Specifier/Regulator
Mar 29, 2012
1
Where is it stated about ordering of dimensions in cad notations
width then hieght, width then legth then hieght, etc.
 
Replies continue below

Recommended for you

Could you give some context?

For slots ASME Y14.5M-1994 shows width then length in figure 1-35.

Otherwise I'm not aware of a convention for this - usually it's indicated in drawing views unless I'm missing something.

Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor