Wildfire 2 Questions

[AdinKent]

Hi all.

I have just started using WF2. I used to use 2001 and I am trying to locate the commands I like using but I can not find a few, wondering you guys can help?

1) Show supressed items in model tree (it was already set on my old machine)

2) Repeat assembly in assembly mode (very useful for fixings etc)

3) In drawings independently keep certain tan lines and then switch tan lines off which erases the ones I did not want to keep.

I am probably being dumb not knowing the above but I cant find it!

AD

 

[3dlogix]

1) In the Model Tree tabs, select SETTINGS and select TREE FILTERS.

2) Highlight the component on screen, select EDIT, REPEAT in the file menus.

3) Pick the drawing view on screen, and pick VIEW, DRAWING DISPLAY.

http://www.sprdesign.com

http://www.3dlogix.com

 

[mjcole]

Here are some Valuable links that will help out.
These normally show at the site

http://www.ptc.com/community/proewf2/newtools/index.htm

which usually shows up in the Pro/E browser when you launch Pro/E.

Pro/ENGINEER Wildfire Menu Mapper

http://www.ptc.com/community/proewf2/menu_mapper/en/index.htm

For 2001 menus here are the direct links.
Assembly

http://www.ptc.com/community/proewf2/menu_mapper/en/2001_to_wf2_assembly/index.htm

Part

http://www.ptc.com/community/proewf2/menu_mapper/en/2001_to_wf2_part/index.htm

Drawing

http://www.ptc.com/community/proewf2/menu_mapper/en/2001_to_wf2_draw/index.htm

Michael

 

[AdinKent]

Thanks guys, spot on.

AD

 

[alphaguru]

Additionally, for case 3, if you want to show or erase only 1 tan line (not all in a particular view) you can go to View>edge display>from here you can hide/unhide and set fonts ect.