Wildfire 5.0 I have an assembly,

[jounnytrep]

Cabling Wildfire 5.0

I have an assembly, connector A, connector B, and a set of wires connecting both. When I change location of connector B the wires stretches accordingly. The problem is, when I use a family table to relocate connector B to various locations, the wires do not stretch to the length required, it stays in the generic length.

Anyone can help

Thanks

 

[3DDave]

You may have to create a family table of the wires and place them into the assembly instances. Each wire model can have only one shape at any given time.