Wire EDM NX4

[bcl001]

What is the correct way to select a wireframe geometry with multiple members [lower] as boundary for wire EDM using UGS-NX4. I get always the error message "missing side lines". I can select up to 2 members without any message.

Thanks in advance , Bert

 

[joycejo]

The top and bottom boundary segments need to be connected.
Add lines between the segments at each end point.
I think you need the same number of segments for the top and bottom boundaries.

John Joyce
Tata Technologies iKS
1675 Larimer St.
Denver, CO

http://www.myigetit.com