Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Workbench and APDL Parameterization Question

Thread starter mdan90
Start date Jan 2, 2018

Status: Not open for further replies.

Jan 2, 2018

mdan90

Mechanical

Hello All,

I am trying to perform a simple optimization of a cylinder where the surface area is minimized. I couldn't find a way to parametrize the surface area in both Workbench and APDL. I would be glad if anyone could help me with this.

Thanks,
mdan