GeorgeEllwood
Mechanical
Hello,
I'm using workbench and would like to automate the creation of lots of coordinate systems based on geometry parameters.
I've found a way to do it by creating planes in design modeller and then exporting them for use later but it's a very convoluted way to do it and is time consuming.
Is there an easier way to do it? I used to use a plane to split the geometry to create a vertex which I then used to create a coordinate system. but I don't want to put too many splits in this geometry so have avoided this method.
Many thanks
George
I'm using workbench and would like to automate the creation of lots of coordinate systems based on geometry parameters.
I've found a way to do it by creating planes in design modeller and then exporting them for use later but it's a very convoluted way to do it and is time consuming.
Is there an easier way to do it? I used to use a plane to split the geometry to create a vertex which I then used to create a coordinate system. but I don't want to put too many splits in this geometry so have avoided this method.
Many thanks
George