Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Working with tables

Thread starter achrysov
Start date Sep 5, 2010

Status: Not open for further replies.

Sep 5, 2010

achrysov

Structural

Hi,

I want to perform a non-linear analysis, so i want to input a table to the load case so that the load applies gradually on my structure. The problem is that i have allready assigned a table to this load (type of z0 coordinate).

Is it possible to assign two tables at a boundary condition?

Thanks in advnace,Antony.