WRC 107 Cal

[mechyp]

dear all

message coming below table of Dimensionless load

the ! mark next to the figure name denotes curve value exceeded.

why this message is coming and how to avoid it

yogesh

 

[TGS4]

The curves used in WRC 107 calculations are bounded by finite limits. Some software will extrapolate (not recommended), while others will just warn you. If you exceed the limits, then WRC 107 cannot be applied.

Please find a copy of WRC 107 and read it, before using an automated calculation that implements them. Then, you will understand what you are dong, and not just being a button-pusher.