Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Write out IGES file

Thread starter Fulmer
Start date Nov 25, 2003

Status: Not open for further replies.

Nov 25, 2003

Fulmer

Mechanical

I am trying to export a deformed 2D model from ANSYS to an IGES file. The model was built in UG and was solved yeilding a deflect part. I was curious to know if there were any macros out there that could take this deflected shape and write it out so it could be imported back into UG.

Thanks