XYZ coordinate/point table for ipipework

[SiW979]

Would anybody please have some grip or simillar which will allow me to create an associative table where the X, Y and Z values are linked to points in the model? Basically I want to be able to chart the X, Y and Z points of the intersections of bends for our hydraulic pipework and if I then move one of the points, I would love to a table to update automatically.

I have attached a basic sample of a typical pipe constructed using points and associative lines if you translate/move the points, then the pipe will update automatically. Many thanks in advance

Best regards

Simon (NX4.0.4.2 MP9 - TCEng 9.1.3.6.c)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...

 

[FXjohn]

If you purchase the GM toolkit, the program called pipe.grx does that.

 

[SiW979]

Where do we buy this from? Siemens? and how much is per seat roughly?



Best regards

Simon (NX4.0.4.2 MP9 - TCEng 9.1.3.6.c)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...

 

[FXjohn]

I think you buy it from gmsupplypower.com