Yokogawa Micro XL DCS Should I throw it out ?

[magnetchief]

Looking for a little advice.
What should I do with the following?

The system was upgraded to Mighty MOPS, and one of the two consoles has a new monitor and a new hard drive (less than 2 months use).

We swapped the system out less than a year ago for a Yokgawa CS3000 system, and the system has been stored covered in an air conditioned space since then.

We have all the software and manuals for each console and FCU.

Each operator station has an EN83 ethernet card, printer cards, and engineering keyboards.

Here is a breakdown of the equipment in the photos:

2 Mighty MOPS stand alone Operator Consoles OPS12 and OPS11.
2 Continuous feed alarm printers.

7 Field Control Units with the following breakdown of component cards:

FCU-A - PS31 * A QTY 2
NP53 * C QTY 2
VM1 * D QTY 3
VM2 * D QTY 1
ST6 * A QTY 1
ST5 * A QTY 1
ST7 * A QTY 1

FCU-B - PS31 * A QTY 2
NP54 * C QTY 2
VM1 * D QTY 3
PX1 * A QTY 1
ST6 * A QTY 1
ST7 * A QTY 1

FCU-C - PS31 * A QTY 2
NP54 * C QTY 2
RS2 * B QTY 1
ST6 * A QTY 1
ST5 * A QTY 1
ST7 * A QTY 1

FCU-D - PS31 * A QTY 2
NP53 * C QTY 2
ST6 * A QTY 1
ST7 * A QTY 1

FCU-E - PS31 * A QTY 2
NP53 * B QTY 2
VM1 * D QTY 3
VM2 * D QTY 1
ST6 * A QTY 2
ST5 * A QTY 1
ST7 * A QTY 1

FCU-F - PS31 * A QTY 2
NP53 * C QTY 2
ST6 * A QTY 2
ST5 * A QTY 1
ST7 * A QTY 1

FCU-G - PS31 * A QTY 2
NP54 * C QTY 2
RS2 * B QTY 1
ST6 * A QTY 2
ST5 * A QTY 1
ST7 * A QTY 1
--

It would be nice to find a buyer who could use this equipment.
Any advice greatly appriciated.