Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Cp for DMA diesel?

Status
Not open for further replies.
Replies continue below

Recommended for you

Sort by date Sort by votes
Will you accept Btu/Lb-F ? Should be around 0.5 Btu/Lb-F

I'm usually not far off with this,

Cp = 0.6811 - 0.308*SG + (0.000815-0.000306*SG)* tF)*(0.055*12 + 0.35)

SG = specific gravity at 60F
tF = Fluid temperature F

BigInch[worm]-born in the trenches.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

edgardoom
  • Question
Ideas of softwares for Oil and Gas industry
Replies
1
Views
620
1503-44
1503-44
ncnpiping
  • Locked
  • Question
Pickling and Passivation for SS weld joints
Replies
4
Views
417
EdStainless
EdStainless
johndoe_123
  • Locked
  • Question
Olga Simulation for Dynamic Pipeline Transportation
Replies
7
Views
289
1503-44
1503-44
Babyblue99
  • Locked
  • Question
Wire Mesh for Open Vent Fuel Storage Tank
Replies
3
Views
514
shvet
shvet
Johan Rivera
  • Locked
  • Question
Composition of Nitrogen/Helium for Leak Test of process piping
Replies
3
Views
412
EdStainless
EdStainless

Part and Inventory Search

Sponsor

Back
Top Bottom