Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Error message

Status
Not open for further replies.
blckwtr

blckwtr

Mechanical
Oct 30, 2006
204
Using shell for meshing, loads and restraint applied, I get an error message:

No loads are applied to the model.

What is wrong?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Make sure that loads and restrainsts are applied to the same surface that you used to generate the shell.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

oharag11
  • Locked
  • Question
Error - Please enter a value greater than 0 - Thermal Joint?
Replies
0
Views
375
oharag11
oharag11
pllmoreau
  • Locked
  • Question
Solidworks Simulations Bearing Load error
Replies
4
Views
570
pllmoreau
pllmoreau
IdanPV
  • Locked
  • Question
Error Message - SolidWorks Simulation
Replies
2
Views
296
IdanPV
IdanPV
cbrf23
  • Locked
  • Question
How to interpret error message? "For plasticity models, raise: ETAN > Ex/100"
Replies
0
Views
200
cbrf23
cbrf23
PacoB
  • Locked
  • Question
Error Solidworks simulation
Replies
0
Views
25
PacoB
PacoB

Part and Inventory Search

Sponsor

Back
Top Bottom