Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COSMOS error message: unable to open temporary files

Status
Not open for further replies.
esullwold

esullwold

Aerospace
Feb 28, 2007
1
Everytime I try to mesh my simple part solidworks displays the message:

unable to open temporary files

and promptly crashes

What the hell does that mean?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Make sure you have read/write access to the temporary directory. Also check that the working directory is not full (where the TEMP and TMP environment variables point). If this does not work then repair the installation of SW/COSMOS.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

oharag11
  • Locked
  • Question
Error - Please enter a value greater than 0 - Thermal Joint?
Replies
0
Views
372
oharag11
oharag11
pllmoreau
  • Locked
  • Question
Solidworks Simulations Bearing Load error
Replies
4
Views
567
pllmoreau
pllmoreau
IdanPV
  • Locked
  • Question
Error Message - SolidWorks Simulation
Replies
2
Views
293
IdanPV
IdanPV
dlagr21
  • Locked
  • Question
How to fixture plate for stepping scenario
Replies
3
Views
372
FEA way
FEA way
ElMicha
  • Locked
  • Question
How To Run FEA on Nut-Bolt Assembly 1
Replies
7
Views
486
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top Bottom