Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

COSMOS crashing SW

Status
Not open for further replies.
NL8

NL8

Mechanical
Aug 13, 2007
633
Has anybody had this issue:

Model a part in SW, Switch to COSMOS, system works fine.
Build a simple assembly in SW, switch to COSMOS, runs fine.
build a model with more than 8 parts it seems, switch to COSMOS, SW crashes.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
turns out it is a specific part that is cause it, but i'm not sure what is special about this part to cause this problem.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

jacob999
  • Locked
  • Question
COSMOSM
Replies
3
Views
109
3DDave
3DDave
SWISGR8
  • Locked
  • Question
SW Properties disappearing when saving dwg as PDF
Replies
0
Views
65
SWISGR8
SWISGR8
bigbertha912
  • Locked
  • Question
How good is Cosmos/Simulation at analyzing Composite Honeycomb panels 1
Replies
2
Views
69
bigbertha912
bigbertha912
Bobfromoh
  • Locked
  • Question
COSMOS Output Files
Replies
0
Views
61
Bobfromoh
Bobfromoh
Mykolas
  • Locked
  • Question
how correctly to describe geometry? (COSMOS/M)
Replies
0
Views
49
Mykolas
Mykolas

Part and Inventory Search

Sponsor

Back
Top Bottom