Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Member Forces for Connection Design

Status
Not open for further replies.

eit09

Civil/Environmental
Jul 8, 2009
183
Risa Default for sections is 5. If I adjust this value to 2 sections would this give me the end member forces? I would assume that the I end would be section 1 force and the J end would be section 2 force. The purpose of this adjustment would be to obtain the forces for the connection design quick.
 
Replies continue below

Recommended for you

Yes - we've done that as well.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor