Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Trouble with trail files.

Status
Not open for further replies.
DevO

DevO

Mechanical
Dec 28, 2000
13
I am having trouble trying to run a trail file.
I cannot figure out how to do it in 2000i2.
If anyone can help me with this problem I would appreciate it.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
I found the problem with my trail files.
I had to take the extensions off of the file for it to recognize the file.
Hope this helps someone else.
 
Upvote 0 Downvote
trail file must have standard two line comment header
cut and paste from current trail file
trail file needs renaming to *.txt extension not *.txt.111 etc
use utilities train/trail and navigate to reqd *.txt file to run trail file
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

B
  • Question
with lookup_inst function variants change family table via parameters
Replies
1
Views
723
3DDave
3DDave
whatev-nvm
  • Locked
  • Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
461
whatev-nvm
whatev-nvm
JDP_CAD
  • Locked
  • Question
Public geometry issue with Creo8
Replies
2
Views
119
JDP_CAD
JDP_CAD
samim09me
  • Locked
  • Question
creo 4.0 with 3dexperience connector mxpro issue
Replies
0
Views
90
samim09me
samim09me
kaengo
  • Locked
  • Question
Problems with Creo 3.0 Graphics
Replies
0
Views
96
kaengo
kaengo

Part and Inventory Search

Sponsor

Back
Top Bottom