rick13t
Mechanical
- Jun 13, 2016
- 2
Hello,
I am trying to run a CFD flow simulation on a car that I have created in NX 9.0.
The car is about 15 inches long. 6 inches wide. and 5 inches tall. It is roughly a 1/12th scale car.
After creating meshes in fem and putting in boundary flow conditions and flow surface conditions in sim, I hit solve.
It solves without a problem.
However, when I go to click Results after the solution is completed, it says: "The file D:\Simulation 1 - Without Vortex Generators\Normal Length Spoiler-0\assembly1_sim1-Solution_1.bun is not found". I have attached a screenshot of the error message.
I have no clue how to solve this problem. Any help would be appreciated.
Please let me know if I need to elaborate further.
Cheers,
Mechatronics Engineering Student, Rick
I am trying to run a CFD flow simulation on a car that I have created in NX 9.0.
The car is about 15 inches long. 6 inches wide. and 5 inches tall. It is roughly a 1/12th scale car.
After creating meshes in fem and putting in boundary flow conditions and flow surface conditions in sim, I hit solve.
It solves without a problem.
However, when I go to click Results after the solution is completed, it says: "The file D:\Simulation 1 - Without Vortex Generators\Normal Length Spoiler-0\assembly1_sim1-Solution_1.bun is not found". I have attached a screenshot of the error message.
I have no clue how to solve this problem. Any help would be appreciated.
Please let me know if I need to elaborate further.
Cheers,
Mechatronics Engineering Student, Rick