Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

ETABS MODEL CHECKING MEMBERS TOO CLOSE TO EACH OTHER

Status
Not open for further replies.
PSR_1

PSR_1

Civil/Environmental
Aug 9, 2016
56
The error shown in the picture keep bugging me in ETABS V 16.2.1. AS CSI website recommeded I tried exporting and importing the model, but the error still happen to be there. Is there any way to resolve it.
4_ewgvbl.png
 
Replies continue below

Recommended for you

Sort by date Sort by votes
It's telling you that you may have duplicate members. Have you gone to those node locations to see if you can figure out what it's talking about?
 
Upvote 0 Downvote
Or sometimes things aren't quite connected or are overlapping slightly. Pick the locations one by one and zoom in.

Sometime splitting the members at a joint where you have a beam spanning onto another member helps you align and connect things.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Stockton2008
  • Question
How to model concrete slabs in Etabs
Replies
0
Views
706
Stockton2008
Stockton2008
H
  • Question
ETABs API- Sapmodel
Replies
2
Views
2K
sticksandtriangles
sticksandtriangles
Stockton2008
  • Question
How to define ultimate and service load combos in Etabs
Replies
1
Views
607
Luceid
Luceid
Stockton2008
  • Question
How to set displacement ratio (storey drift ratio) check in Etabs
Replies
0
Views
360
Stockton2008
Stockton2008
hamedall
  • Locked
  • Question
ETABS API-2016
Replies
2
Views
578
hamedall
hamedall

Part and Inventory Search

Sponsor

Back
Top Bottom