Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

GDT Counterbored Slots

Status
Not open for further replies.
njm789

njm789

Automotive
Oct 9, 2019
25
US
Hi All,

What is the proper way to tolerance counterbored slots using GDT. In my case I don't care about tight tolerance on the horizontal position of the thru slot just the spacing, though obviously the counterbore itself needs to follow the contour of the thru slot. Any advice is greatly appreciated. See picture below.
GDT_Slot_yb7nkj.jpg
 
Replies continue below

Recommended for you

Sort by date Sort by votes
If this is for clearance, then just use a profile tolerance on each side of the through slot relative to each side. Using position for clearance like this is probably an unnecessary complication.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ShlomoB
  • Locked
  • Question
Sliding fit using GDT
Replies
8
Views
33
CheckerHater
CheckerHater
nmine
  • Locked
  • Question
Sheet Metal Part GDT
Replies
5
Views
20
3DDave
3DDave
Diametrix
  • Locked
  • Question
Slots center plane orientation
Replies
10
Views
32
jassco
jassco
rkrz
  • Locked
  • Question
GDT on machined extruded part 1
2
Replies
22
Views
63
3DDave
3DDave
Words_In_Sequence
  • Locked
  • Question
Tolerancing Slots From an Angled Datum 3
Replies
13
Views
43
Words_In_Sequence
Words_In_Sequence

Part and Inventory Search

Sponsor

Back
Top