Sep 26, 2023 #1 Diametrix Aerospace Jan 31, 2023 50 I wanted to verify if the two definitions for the feature(s) designated as datum A in the picture below are equivalent
I wanted to verify if the two definitions for the feature(s) designated as datum A in the picture below are equivalent
Sep 26, 2023 #2 Garland23 Mechanical Dec 4, 2021 106 Yes, they are. In the ASME Y14.5-2018 standard, this pertains to paragraph 5.8.3 and 5.8.4. Upvote 0 Downvote
Sep 26, 2023 #3 Burunduk Mechanical May 2, 2019 2,358 They are, but only in this special case of 0@MMC. Upvote 0 Downvote
Sep 26, 2023 #4 greenimi Mechanical Nov 30, 2011 2,261 Just curious: do you still need 2X when CF is used? I don't think so..... Upvote 0 Downvote
Sep 26, 2023 #5 Burunduk Mechanical May 2, 2019 2,358 greenimi, you don't. The goal is to communicate that it's treated as a single feature. Upvote 0 Downvote
Sep 26, 2023 Thread starter #6 Diametrix Aerospace Jan 31, 2023 50 greenimi said: Just curious: do you still need 2X when CF is used? I don't think so..... Click to expand... Good catch! Sorry about that, forgot to delete it when I edited the picture. Fixed Upvote 0 Downvote
greenimi said: Just curious: do you still need 2X when CF is used? I don't think so..... Click to expand... Good catch! Sorry about that, forgot to delete it when I edited the picture. Fixed
