Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

heating rate applicable for normalisation of Dish end for pressure vessel

Status
Not open for further replies.
Muza33

Muza33

Mechanical
Jul 27, 2023
9
Dear Experts,


Does any heating rate (controlled heating rate degree celsius per hour)is applicable for normalisation heat treatment of Dish end for pressure vessels?

i could not find any reference on code ASME 8 .
 
Status
Not open for further replies.

Similar threads

Muhammad Ijaz
  • Locked
  • Question
Availability of 3mm thick As rolled ASTM A516 70 plate normalized and impact tested
Replies
0
Views
473
Muhammad Ijaz
Muhammad Ijaz
Christian Dimitrov
  • Locked
  • Question
Forged flanges in A182 F347 1
Replies
7
Views
399
EdStainless
EdStainless
Muhammad Ijaz
  • Locked
  • Question
Hydrostatic test of tubes
Replies
1
Views
315
EdStainless
EdStainless
ValvEng05
  • Locked
  • Question
Allowable stress value of A453 660 D Studs
Replies
0
Views
313
ValvEng05
ValvEng05
harmsgundam
  • Locked
  • Question
ASTM C150 on Heat of Hydration Requirement
Replies
0
Views
325
harmsgundam
harmsgundam

Part and Inventory Search

Sponsor

Back
Top Bottom