Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

how to show Pneumatic diagram with options

Thread starter Nathan Gardner
Start date Nov 6, 2023

Status: Not open for further replies.

Nov 6, 2023

Nathan Gardner

Mechanical

I have only done a few and it has been many years since I have created any kind of PIDs. I have a product I need to create a PID for. This diagram will always have the CO2 source, and from there, it may have a CO2 backup and or N2 source. If there's an N2 source, they could be an additional N2 backup. How should I show this in one diagram with line types?