Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

A333 gr6 plastic properties 1

Status
Not open for further replies.
Anatoly_k

Anatoly_k

Mechanical
Apr 21, 2022
10
Hi ALL,

I am trying to do nonlinear analysis of a piping element in Ansys but struggling to find plastic properties of A333-6. If anyone has it, I would be thankful if you could share the information here.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
ASME Section II, Part D has Table Y-1 for the yield stress, and Table U for the ultimate stress. You could generate a true stress-true strain curve using the method in ASME Section VIII, Division 2, Annex 3-D.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Ehsan301
  • Question
SAW weld for ASTM A333 Gr. 6 (deviation from standard)
Replies
8
Views
3K
GD2
GD2
WJS1962
  • Locked
  • Question
Limitiation on OD for A333 Pipe
Replies
9
Views
139
WJS1962
WJS1962
quizzical1
  • Locked
  • Question
Best plastic to use for potable hot water
Replies
3
Views
110
quizzical1
quizzical1
MatMan83
  • Locked
  • Question
EN 13480-3 wall thickness calc material properties.
Replies
2
Views
119
JeroenPh
JeroenPh
MJCronin
  • Locked
  • Question
Seven Dead -NTSB report Plastic Fitting Failure -- PA Chocolate Factory- Explosion and Fire
Replies
0
Views
54
MJCronin
MJCronin

Part and Inventory Search

Sponsor

Back
Top Bottom