ABAQUS AM PLUGIN LDED

busbeben · Jun 10, 2024

Hello I am working on LDED. there is an experimental result of the temprature value of each point that the laser touches while scanning. I am doing the same analysis with the Abaqus model. But I can't set the step. that is, the experimental data is too much, but I can't get the temperature information every second in Abaqus. I share my experimental result and abaqus model's result.
Could you hep me?

Ekran_Al%C4%B1nt%C4%B1s%C4%B1abaqus_uryaet.png

Ekran_Al%C4%B1nt%C4%B1s%C4%B1_zxcqxo.png

FEA way · Jun 11, 2024

To get history output in Abaqus every second, you should set the maximum increment size to 1 s and then make sure this history output is requested every increment or every second (there is such a setting for output frequency as well).

busbeben · Jun 11, 2024

thank you. The step setting of my model is as in the picture. maximum 4. Because the experimental run of my model took 4 seconds.

FEA way · Jun 13, 2024

If the experiment lasted for 4 s then you should set the time period of the step (Basic tab) to this number. The maximum increment size should be much lower to capture the transient behavior properly.

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

ABAQUS AM PLUGIN LDED

busbeben

Student

Recommended for you

FEA way

Mechanical

busbeben

Student

FEA way

Mechanical

Similar threads

Part and Inventory Search

Sponsor