Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Is it possible to calculate punts using RPMs in an extruder

Thread starter CarlosGarza10
Start date Jul 30, 2024

Status: Not open for further replies.

Jul 30, 2024

CarlosGarza10

Industrial

1 of my customers is trying to get pounds per hour. Is it possible to calculate the pounds produced according to the RPMs?
My concern is that I'm overthinking, and I can probably only use a standard rate of Pounds per hour instead of doing an intrusive installation to get RPMs.