Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Strenght Ratio is Zero but I have a Failurer Index

Status
Not open for further replies.
martin555

martin555

Aerospace
Nov 30, 2018
17
Hi

I am running a FEMAP model of a simple laminate loaded in compression and tension.
I have PARAM SRCOMPS YES selected.
But when I output the strength ratio they are coming out as 0.
I had failure indices and strains but for some reason the SR =0
 
Status
Not open for further replies.

Similar threads

brut3
  • Locked
  • Question
Model Meshing Issues
Replies
6
Views
2K
SWComposites
SWComposites
MrRogers1987
  • Locked
  • Question
FATAL MESSAGE 4129 Zero Area Element
Replies
1
Views
244
BlasMolero
BlasMolero
Itxusta
  • Locked
  • Question
2d axisymmetric analysis of a revolution part
Replies
3
Views
776
Itxusta
Itxusta
martin555
  • Locked
  • Question
EMA IS USED. INSUFFICIENT MEMORY SPECIFIED FOR EMAINC
Replies
3
Views
618
BlasMolero
BlasMolero
ThomasH
  • Locked
  • Question
"matrix is not positive definite"-question 1
Replies
13
Views
692
ThomasH
ThomasH

Part and Inventory Search

Sponsor

Back
Top Bottom