Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

torquing (or) tensioning timings for all flange sizes

Status
Not open for further replies.
chandra sekar

chandra sekar

Mechanical
Jun 29, 2023
5
Do anyone have the timing details of the flange torquing or tensioning for all flange sizes for the purpose of shutdown planning and execution. If anyone have those details, please share it.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Bolt torque used in fanged joints depends on required gasket clamping force. If you are asking for plant wide advice, you should try a resource like the Garlock Gasket Calculator.

More Information = better answers
 
Upvote 0 Downvote
I think the OP wants a ROT or guide on how long it takes to properly torque up different sized flanges. Which I guess also varies by flange class.

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

hamidinho
  • Question
Flange to pipe misalignment
Replies
3
Views
1K
goutam_freelance
goutam_freelance
Arron_
  • Question
Looking for a high pressure flange supplier 2
Replies
10
Views
353
jietepipefittings
jietepipefittings
sider
  • Question
Threaded Flange on 6" Pipe
2
Replies
27
Views
5K
racookpe1978
racookpe1978
O
  • Question
O-Ring flange screw torque
Replies
7
Views
978
GD2
GD2
rudiawan .
  • Locked
  • Question
spreadsheet or software for steam tracing calculation
Replies
4
Views
332
FacEngrPE
FacEngrPE

Part and Inventory Search

Sponsor

Back
Top Bottom