Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hi everyone, please assist. What is

Status
Not open for further replies.

Ohuti

Mechanical
Sep 12, 2024
3
Hi everyone, please assist. What is the typical thermal oil volume flow rate for particleboard pressing?
 
Replies continue below

Recommended for you

Just a little bit of additional info might assist, but please don't over do it and confuse everyone.

It is a capital mistake to theorise before one has data. Insensibly one begins to twist facts to suit theories, instead of theories to suit facts. (Sherlock Holmes - A Scandal in Bohemia.)
 
Is this a repeat of your other post?

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor