hardness at 5/8 inches depth to the face

patricepage · May 22, 2003

Hi,

I have a 13 inches wheel by 3 inches thickness that got an heat treatment. I want to know if it's possible to get the hardness at 5/8 inches depth to the face, without destroy the pieces.

I don't have a jominy test or a sampler.

Maybe a magnetics or ultrasonic testing can do?

Carburize · May 22, 2003

What kind of heat treatment was performed? Through hardening or some form of surface treatment (flame, induction?)

mqas · May 22, 2003

The depth of hardening achieved would depend on the material grade of the wheel and the type of heat treatment performed. However,irrespective of the these it would be impossible to verify the hardness at a specific depth on the actual component without cutting samples from the component for cross a section hardness survey. If this is not possible then you could recreate the heat treatment on test piece using the same material grade. This could then be used to verify the hardness levels at the depth you require.

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

hardness at 5/8 inches depth to the face

patricepage

Mechanical

Recommended for you

Carburize

Materials

mqas

Materials

Similar threads

Part and Inventory Search

Sponsor