Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Software/Programs??

Status
Not open for further replies.

Russellccooper

Geotechnical
Dec 27, 2002
14
I am in a siutation that demands that I produce a large amount of steel details for pile cages (Small Diameter)although he cages are all pretty standard the process is time consuming. I have heard a rumour that a program (Visual basic most likly) is floating around that allows cage details to be drawn in excel simply by entering bar sizes and numbers? Does anyone know of any such sheet? I also think that this sheet may have an element of pile design built into it maybe it was just a very good dream!!
Any help on this matter would be deeply appreciated
 
Replies continue below

Recommended for you

Haven't heard of that one; I am aware of a program produced by ACI for columns that I have used in the past for drilled piers. As I recall, it costs about $750 a copy - and does a lot more that just detailing.

[pacman]
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor