Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Metal and Metallurgy engineering

?
  • Locked
  • Question
EROSION
Replies
1
Views
40
tedg
tedg
JOHNRR
  • Locked
  • Question
Are there any drawbacks to....
Replies
0
Views
41
JOHNRR
JOHNRR
alek
  • Locked
  • Question
Calculate radius and angle for a forming punch for bending sheet metal
Replies
0
Views
48
alek
alek
Ryan9
  • Locked
  • Question
Forged 4140 to Simalar Metal
Replies
1
Views
57
tedg
tedg
Vai
  • Locked
  • Question
Polishing Alloy with a rough surface
Replies
1
Views
53
Fabrizio
Fabrizio
Dragon
  • Locked
  • Question
Replacement for HF in pickling solutions...
Replies
0
Views
38
Dragon
Dragon
hrvat
  • Locked
  • Question
Aluminum 6061 T4 for 380 prototype??
Replies
4
Views
77
diamondjim
diamondjim
Vai
  • Locked
  • Question
Polishing Alloy with a rough surface
Replies
0
Views
41
Vai
Vai
iamchoyh
  • Locked
  • Question
Galvanic Corrosion between A7050 and A2024 and A7075
Replies
0
Views
45
iamchoyh
iamchoyh
carbide
  • Locked
  • Question
Magnetic permeability of Cronite HR6 or RA-330 stainless?
Replies
0
Views
49
carbide
carbide
Dragon
  • Locked
  • Question
Good cleaner for metal tubes?
Replies
0
Views
34
Dragon
Dragon
?
  • Locked
  • Question
Failure Analysis and Prevention
Replies
2
Views
55
arunmrao
arunmrao
Martyn
  • Locked
  • Question
Welding 3CR12 Ferritic Stainless Steel
Replies
0
Views
41
Martyn
Martyn
slick
  • Locked
  • Question
carbon steel
Replies
0
Views
42
slick
slick
raspoutin
  • Locked
  • Question
zincum
Replies
1
Views
56
neil71
neil71
Dragon
  • Locked
  • Question
Problems with metal stains, etc. 1
Replies
2
Views
45
Dragon
Dragon
?
  • Locked
  • Question
CV18W Material
Replies
0
Views
47
-
?
eureka
  • Locked
  • Question
Material Identification
Replies
1
Views
50
Consulting
Consulting
kapellah
  • Locked
  • Question
calculating required length of tube needed for cutting
Replies
0
Views
35
kapellah
kapellah
warburton1
  • Locked
  • Question
Relative cost of Aluminum Grades
Replies
0
Views
48
warburton1
warburton1
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom