Recent content by A. Polyp

Hello! I have got a question that I find difficult to assign to a specific forum. I am using Ansys, so for the best of my knowledge I will try it here but if a moderator thinks it should be asked in a more general engineering thread, feel free to move the post. I am simulating a ceramic...

hey thanks for your reply. I wonder how optimization programs like ISIGHT work, which are aimed to change the geometry in a defined way but should (apart from the geometry) conduct the same FE analysis again and again...

Dear all, when I use the Geometry Interface for SolidWorks only volumes and shells are transfered but no reference geometry elements like points, axes, planes. I need at least a reference point that is defined in my SW assembly for a MPC constraint. Is there a way to include the export of those...

Thanks for your quick help, I will try this!

hey ! I ve got a question concerning rigid bodies / connectors (I am realtively knew to abaqus but have a lot of experience with ansys). I made a simplification of my problem: a c-shaped geometry (see attached picture) which is loaded with a single force. I want a rigid wire inbetween (no...