Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by AmoorSaleh

  1. AmoorSaleh

    joint efficiency of the welds

    Hello Duwe6's and weldstan, Thank you a lot .. [smile] I agree with you that it is a very poor design!! But in this case the E joint efficiency should be 0.8, is it true? According to UW-12
  2. AmoorSaleh

    Allowable stress values in ASME sec.II D & ASME B31.3

    Sometimes there is no different in the type name, but the values is totally different, i suggest to you to find the UN number.
  3. AmoorSaleh

    joint efficiency of the welds

    Dear All, I need your help choosing the joint efficiency of the welds, Assume Given:- • hemispherical head which assembled to the shell by "type No (2):- single Welded butt joint with backing strip… see sketch UW-13.1 (i) ". • the manufacturer decides to do Spot just for the...
  4. AmoorSaleh

    Does Asme Accept Full Face Flange Calculation According The Pd 5500?

    thank you a lot.. from clause 2-1(e) i understood that yes.. it is acceptable and there is no prevention to use this type of flange if it is designed according to the acceptable design method !! [bigsmile]
  5. AmoorSaleh

    Does Asme Accept Full Face Flange Calculation According The Pd 5500?

    Hello there. could you explain to me please: is the design calc. according PD 5500 for the full face type is sufficient according to ASME VIII Div.1? as far as i know there is no reference in Asme calc. to this type !! Does ASME accept this type of flange?
See more

Part and Inventory Search

Back
Top Bottom