Hi,
I have experimental data of a compressed test with Stress-Strain graph like shown below.
In linear elastic region, Stress/Strain do not equal Young modulus.
How can I use this data and reproduce the experiment in ansys./
Thank...
I have a problem about active Coriolis effect in ANSYS Workbench.
The geometry is circular tube and applied Rotation Velocity about Z-axis via command: OMEGA,,,3000
I tried with 3 cases:
1. Active Coriolis effect with Reference Frame = ON (Stationary Reference Frame) -- "coriolis,on,,,on"
2...
Hello everyone, I have a problem regarding EndTime settings between Analysis Settings and Commands Object as follows.
In the Analysis Settings, I leave EndTime = 1s by default
I use Commands Object to impose the load and set the EndTime as follows:
*DIM,loadvari69y,TABLE,2,1,1,TIME,
! Time...
Hi,
Thank you for your reply.
I tried that code but the result was not satisfactory.
I understand in that code that the elements with stress greater than the predetermined value and the surface area of the elements are calculated.
In the case I am trying to achieve, it is the area on a surface...
Hi everyone,
After completing the solution, I can exploit the results on the body.
But how can I determine the area of a region with stress (or any result) greater than the predetermined value?
For example, the figure below is the stress result of one face, I want to calculate the area of the...