Search results for query: *

I want to perform this problem: http://anyflip.com/micz/pzne/basic

Yes, but in that grap, linear elastic region, relationship between Stress-Strain is not Linear, which is the curve. I dont understand it

Hi, I have experimental data of a compressed test with Stress-Strain graph like shown below. In linear elastic region, Stress/Strain do not equal Young modulus. How can I use this data and reproduce the experiment in ansys./ Thank...

I have a problem about active Coriolis effect in ANSYS Workbench. The geometry is circular tube and applied Rotation Velocity about Z-axis via command: OMEGA,,,3000 I tried with 3 cases: 1. Active Coriolis effect with Reference Frame = ON (Stationary Reference Frame) -- "coriolis,on,,,on" 2...

Hello everyone, I have a problem regarding EndTime settings between Analysis Settings and Commands Object as follows. In the Analysis Settings, I leave EndTime = 1s by default I use Commands Object to impose the load and set the EndTime as follows: *DIM,loadvari69y,TABLE,2,1,1,TIME, ! Time...

If can, please share that project. Everyone can check it.

Thank you very much I have understood and applied successfully.

Hi, Thank you for your reply. I tried that code but the result was not satisfactory. I understand in that code that the elements with stress greater than the predetermined value and the surface area of the elements are calculated. In the case I am trying to achieve, it is the area on a surface...

Hi everyone, After completing the solution, I can exploit the results on the body. But how can I determine the area of a region with stress (or any result) greater than the predetermined value? For example, the figure below is the stress result of one face, I want to calculate the area of the...

Hi, Try with this files: https://files.engineering.com/getfile.aspx?folder=20c4d820-c88a-455f-a0ca-05f21d5812e3&file=Submod_dinhan0394@gmail.com.zip

hi, I have result for your code. But how can I upload files here?

It'll like this:https://www.youtube.com/watch?v=ed8NcDsLQC4 or: https://www.youtube.com/watch?v=2yHZVEaGvAI

you can try with the ACT: https://www.youtube.com/watch?v=2zJ7tlvPa6o

Can you share the rst file?

Hi, Check some parameters in your code. Here is result

Hi, In the second picture (with ellipse red) explain the error: License used: Premium, But SOLID226 need Enterprise license. That's reason. Change license to Enterprise and run again

Hi, I mean that, the code follow the link that used can use for other material and get good result. In your case, you don't get temperature maybe due to something wrong in code. Check it carefully.

Hi, I think you have something wrong when setup the problem. Here is other case (based on https://www.sharcnet.ca/Software/Ansys/17.0/en-us/help/ans_tec/tecfricstir.html) using Structural Steel material (not Stainless Steel 304L) and get good result. https://www.youtube.com/watch?v=Na9OunHr88U...

like you, I ran successful problem without any error

In this problem, I think you can have other way to model. That is using Moving Heat instead Tool model. That mean, calculate Heat Power by Pin and Shoulder, then apply and make it moving. With this way, solving time much smaller than Tool model like ansys help. p/s: it's not like your initial idea