We have not used any ACSS. I think we need to make a comprehensive comparison table weighing the options based on the scenario and goal. The qualitative characteristics such as resiliency carries significant weight. Hard to step away from something that has steel in it. More or less, reps...
Logical reason to jump from ACSR to ACCC without considering ACSS? Currently utilizing 477 ACSR on 69 line and being pushing to jump to ACCC without cconsidering any ACSS options.
Rebuilding some 69kV T line in some rolling hills where I am forced to replicate what is there today, H-structures with 600-800' spans. I have recently spec'd ductile poles with Pupi fiberglass crossarms (2 arms, currently spec'ing a single arm), braces, and cross brace arrangement. Curious...
Makes sense, same advice I have received from my supervisor. Take the one you have the best chance of passing. Then as I learn, do and wean ourselves off our consultants, I would feel competent enough to seal any design related to substation and transmission within reason. The prior civil...
Mechanical engineer hired to replace a Civil at a utility coop. Involved with substation and line design. Passed the FE, now what PE should I take? Mechanical Machine Design since it was the field I studied and worked for 5 yrs? Civil Construction, more relevant, though will only utilize a...
drawoh,
Attached is a screenshot. From your statement I am guessing we add a profile tolerance and relate it back to the primary datums along with a parallel tolerance to the opposing face or a perpendicular tolerance to the hole?
I have a cast part with a square counterbore on the the backside of a hole so the nut will seat against the face. I am working on getting my GD&T skills up to speed though wondering the best way to define this feature? Can you still use a diameter position tolerance just as you would with a...
Correct dhengr... I am at the forefront of a redesign and am not using slew gears to have 360 degrees of turning at each track. I just want to make sure my stance is narrow enough with plenty of turn angle at each track (cylinder stroke) to guarantee the machine can match whatever software or...
Anyone have a good source for assisting in calculating HP or torque required for screw augers? My application is an auger for the front of a slip form paver. 18'' fight, 6'' tube, 45-60 rpm max, metering concrete in an open trough concept, so pushing material over material. Overall length is...
