I recently had the door of a car scanned and auto surfaced. The file came in as one body (actually 7 bodies, but 6 of them are so small they are negligible) and I would like to remove part of the body. I have highlighted the area I would like to delete but do not know if it is possible on a...
Thanks @cowski for the response. I did have to download it, I downloaded it again thinking that could have been the issue. I can now start the igs import into UG now but in between the "Status 50%" etc etc lines there is a line in the command prompt that reads
"Sheet body geometry problem...
Hello,
I recently received a rather large .igs (874 mb) but when I try to open or import it into NX (I am using NX6 unfortunately) I get an error. The error given is in a picture attached and all of the info from the log file created is copied below. Anyone come across something like this...
They are services provided by the company that did the scanning. Very expensive work billed by the hour, don't think they use your everday CAD software like Solidworks, NX, etc...
Hello,
I recently got a some parts scanned using a handy Handyscan700. I am now chosing which level of post processing is best for my purposes but am having difficulty. They provided two samples, one is done with reverse engineering and one is done with auto surfacing. I am having trouble...
Thank you for the help! I have been playing around with this synchronous modeling. It appears to be able to do the job (although removing bends is difficult and usually gives errors.) It almost seems like the best way is to remove the face after the bend entirely then use one of the other...
If I have a .prt with one solid body, is it possible to break it down to features and edit them? In the example picture below, I'd like to change some of the bends and cut of the part. If not, what is a good method to be able to take a solid body and edit it...
