Is there a European code (ISO or EN) for welding standards for waste water pump systems? How you qualify welders ? Qualify joints ? Quality standards?
I know there is ISO 9606 which defines how a welder is qualified, but how about specifically within the application? We are an OEM.
Similar...
HR just mentioned to me that our TIG welders should be wearing N95 masks when welding 304 / 316 SS. In all of my 40 yrs of welding I have never heard of this. I have had air quality testing performed to make sure ventilation systems ae working, but never under a helmet.
I have used positive...
The assemblies can be quite large, 4' foot cube and weigh 2,000 lbs. A cabinet would be large, with cranes or hoists to move parts around, ventilation system constraints, labor hours to blast. We had one blasted in our parking lot months ago and it took about 4 hrs. I have designed and built...
We are leaning towards a portable buffing process. Lots of great responses, and some good questions. "What do they want?" As "mfgenggear" states, non technical people do not know what they are looking at and favor the prettier products. Blasting, electropolishing or coatings cost too much...
I am not sure if you are asking that question or making a statement.
The details of the assembly would prohibit that level of uniformity. Some details are cast, extruded or rolled and welded pipe. They just need to look professionally made to a non technical person.
We make waste water pumps from welded commercial pipe fittings. Marketing is asking us to make them "prettier". We currently wire brush and passivate the welds. Electropolishing will be very expensive because of the sizes. Ø 8-12" Dia pipe fitting assemblies can weigh over 1,000 lbs and be...
I work with a lot of younger Engineers and you are not alone. Unfortunately, the knowledge to "join" pieces of metal together ranges from the DIY'r with a Harbor Freight welder in his garage to the Aerospace or Navy Nuclear welder. The knowledge and experience is never given enough credit...
We are an Aerospace Company updating our PQR / WPS format for documenting the welding current on Aluminum. We use Miller Dynasty 400 machines for Manual GTAW. We will be going for NADCAP accreditation soon and would like to glide thru worry free.
What is the preferred method for documenting...
In the Aerospace industry some of our Mfg. Engineers talk about using "cool gel" type of products to minimize distortion during welding. Has anybody used it and had success with it ? I have only used copper bars on flat surfaces as heat sinks.
A square groove is defined as the edge prep on a Butt joint. Basically, square corners with no angles. Process and Group have a lot to do with the max thickness. For example, I would not want to weld a square groove butt joint in Inconel in the GTAW process at 10 mm thick.
We are in need of certifying some more GTAW welders in Aluminum in the Aerospace industry, 1G position. There are a few schools of thought when it comes to fixture design. Some say have a copper backing bar that is grooved out with the largest acceptable root reinforcement with Argon back...
David is correct, I have not been back and have not been getting the emails notifications.
Al (GTAW) answered my question in the beginning. IMHO, I would call it going off on a tangent and not hijacking. Knowledge is awesome especially by the audience here. Thanks
I was told today that we do not allow the ends of WPS test weldments to be tack welded.
I thought and have seen the ends to be tack welded to prevent the root opening too much on a groove joint, also on Tee joints.
We are welding to AWS D17.1
Thoughts on this ?
We are in the process of developing a new part. There are very thin (.005" sheet)sections adjacent to the weld joints. The corner joint materials are a little thicker at .060. Heat transfer is a the challenge.
Years ago I used PTA to weld on very thin base metal without edge melt and burn...
