Recent content by CdoubleZ

so... .25 min on the drawing? this way if it cuts in excess of .25, itll be ok?

oh yeah woops... ok

ok, well the plate is 1/4" thick... its somewhat square, and the cut is somewhat square as well... a fillet on the order of .100 on the inside of the lightening cut, give or take, looks ok from a design standpoint. so should i specify .12 min as the dimension? (1/8 drill) again, im after low...

I am wondering if anyone has a resource for Standard radius callouts. That is, I would like to specify a radius diameter for inside cuts of a plate for example (lightening holes) to enable the cutter to use the same drill bit for cost effectiveness. Does anyone know where can access this...