Rubbing was found between casing wear ring and impeller on last stage. 01 Cooling jacket bolt & lock washer was found missing. It seems that caused stuckness.
Daren!
5 stage barrel type horizontal centrifugal boiler feed water pump got seized during laser alignment. What could be reason ? Shaft on DE & NDE was kept aligned by chain blocks. One maintenance guru says that it could be due to reverse rotation during alignment. According to him , seizure is due...
I have seen Turbine maintenance guys scrapping the bearings (supposedly) for oil wedge. Is there some systematic calculations for scrapping or it is just operating experience among turbine maintenance gurus ? I have worked on large pumps and motors. We donot do it and we rely on designer's...
Degraded elbow that needs replacement
OD : 529mm
ID: 509mm
t: 10mm
(Measurements roughly taken)
I am not well known to this work. I donot find this elbow size in ASME 16.9.
Daren!
There is perpex glass jar installed on the top of the acid storage. Glass jar contains silica gel. With the passage of time glass jar surface has become opaque( not clear). Now we have dismounted the glass jar but are clueless to clean it. Pls guide
Daren!
It seems as if inserted piece in upstream flange is neither orifice nor strainer. May be guage or transducer problem. Try to fix suction piping with rigid support because it can cause vibration, alignment and bearing pre-mature failure issues.
Daren!
Vendor has not provided torque for gland tightening of 10' control valve. Is there can be any rough idea for torque gland tightening? Many 10' valve gland tightening torques that I know vary from 20Nm to 30Nm depending on bolt size.
Daren!
Please check the fits of bearings and bearing housings. I have worked for bearings related maintenance for previous 6 years. Though sufficient data can help to deduce any result but greater probability lies with wrongly maintained/installed bearing housings/bearings.
Daren!
@Artisi ! You are angry.:) But I have limitations on data. Your opinions are worth-working. Moreover, my question was simple that over capacity motor can contribute vibration, especially in motor. But any how many answers are satisfactory.
Daren!
