Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by DBlair126

  1. DBlair126

    Strange "Flat Solid" of Conical Sheet Metal Piece...

    Thanks everyone. Lofted flange didn't quite replicate the geometry, but I did find another work around I'll share in case someone runs across this thread with a similar situation: 1. In Modeling, "Extract Geometry" and selected the inner Face 2. "Thicken", selected the extracted face and...
  2. DBlair126

    Strange "Flat Solid" of Conical Sheet Metal Piece...

    I have several conical pieces of sheet metal (created in Modeling, then Converted to Sheet Metal) which either do not successfully calculate when doing a Flat Pattern or if they do, it creates a strange flat loop... Anyone have an idea of what may be going on? I've done the "clean up" tool and...

Part and Inventory Search