As LI stated, this is a pretty common topic which you can find plenty of info about with a Google search. But, it would also be a little more helpful to get a few more details about what you are looking for and what your conditions are.
What's your pipe transporting?
What phase is it in...
You can check out API RP 686 "Machinery Installation and Installation Design". The following is from Chapter 6 which covers piping. There's also figures that show typical locations of such items.
2.6 Pressure Connections and Thermowells
2.6.1 Pressure measurement connections complete with...
navycaptain,
Although I'm not saying that this should not be a concern, I can't say I've ever heard of it being one before when welding two fittings together.
If you have a beveled LR 90 and a beveled WN flange, then you should be able to weld them together same as you would a beveled LR 90...
Hi navycaptain,
I understand what you're meaning about welding a pup piece of pipe in between the elbow and the flange. My question to you is, why do you think that this is necessary? What benefit do you think it gives to have a pup piece of pipe between the elbow and the PSV outlet flange...
I agree that my first thought would be that it is part of the supplementary requirements in the ASTM standard. I'd check those first.
A333 S1 talks about subsize impact specimens and and as chrysa1975 stated, A671 talks about tension and bend tests.
"Those who know, do. Those that...
A picture of the whole inlet/outlet piping might be a little more helpful to advise on. I agree with the above comments about the inlet pipe size and the lack of isolation valves (from what I can see in the picture), but I don't have any issue with the elbow welded directly to the outlet...
I've seen varying ranges, but what I've see most often falls in line with mrfailure.
Low Carbon Steel - less than 0.20% Carbon (although I've seen this number be 0.15% as well, as mrfailure stated)
Mild Steel - 0.20%-0.50% Carbon
High Carbon Steel - over 0.50% Carbon
As far as why ASTM doesn't...
Well, it can happen in a company of any size. But I would think it probably has a little more prevalence in smaller companies, yeah. Larger companies, especially public, don't have a choice but to have the structure, organization, and internal controls in place in order to succeed for their...
ThinCap,
I feel your pain. This has been a common problem in my organization as well. But that does not mean that it is normal nor should it be.
I am (supposed to be) responsible for managing the workflow and backlog for the piping and drafting teams in my organization. I have been...
You can do a Google search for this and find some references to go by, like what is shown below.
"The only limits in life are those which we impose upon ourselves."
ARUN SIVAN,
I'm not sure where you are from, but perhaps you should get a copy of ASME B16.25 "Buttwelding Ends". It would probably help you answer some of your questions. See below for a short excerpt.
"The only limits in life are those which we impose upon ourselves."
Got it all squared away. Just a miscommunication. The fabricator/procurer who wanted to eliminate the swages actually did want to replace them with type 1 inserts, but the PM (non piper) who relayed the message to me didn't know what he was talking about so he just said to delete the swages...
Thank you both for the responses.
I'm trying to get clarification as to what the reasoning is. If the reasoning is simply to keep all the 3/4" valves consistent as MSX x FSW (there are others in the project that have these same end conditions), then I would still suggest at least adding a...
