Recent content by Drnulouc

Yes thanks, that worked. But I still think it could all be done in sheetmetal.

I don't mean to close it, just bend it so that two walls come together in a straight edge(like the picture on first thread). So that I can unfold it and laser cut the sheet.

Hello, yes i did. But I can't trim or extend the walls to each other. The container stays opened or walls are intersecting. See pictures below.

Hello, I would like to know how to make a container with angled walls in sheetmetal design, so that i can unfold it later. I tried everything, but I can't trim or connect angled walls from each other.Thanks