Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by Engr83

  1. Engr83

    Concrete Mix Design Trial Mixes

    Thank you. They plotted all three mixes on the same curve. But I'm here thinking these are three different mix designs not three different w/c ratios for the same curve.
  2. Engr83

    Concrete Mix Design Trial Mixes

    When you plot the three different water-cementitious material ratio, will the sand content change as well? All three mixes they are plotting have the same #57 stone but Mix 1 has low cement low water high sand Mix 2 is middle of the road Mix 3 has high cement high water and low sand Should all...
  3. Engr83

    Mezzanine Loading Evaluation

    There is light storage up there. I assume the workers will still walk around (hunched over) on top of the mezzanine as well. The mezzanine is already built. I don't need to design it, I need to provide a load capacity. Or do I if this isn't a mezzanine?
  4. Engr83

    Mezzanine Loading Evaluation

    Hi all, I've been tasked with determining the load capacity of a "mezzanine" to meet OSHA requirements. IBC 505.1 General. A mezzanine or mezzanines in compliance with Section 505 shall be considered a portion of the story below. Such mezzanines shall not contribute to either the building...
  5. Engr83

    Rectangular Plate Design - Uniform Load - Simple Support

    Hi all, I'm brand new to this site and all forums for that matter. I'm designing a rectangular storage unit that is basically a control station. The building is a box 10' wide x 30' long x 11'-6" tall. My main question for now is designing the roof. The roof is made of G90 galvanized 11 gauge...

Part and Inventory Search