Irrespective of the age of the pumps, it is the vapour pressure of the oil that dictates the NPSHr.
The vapour pressure of mineral oil is as close to zero as makes no difference. The seals in the pump will be drawn into the pump before the oil boils.
Most pumps have a maximum inlet pressure...
Those of us that don’t add our company name and web link are giving advice for altruistic reasons. You seem to want to fight and argue with everyone and advertise Delta Motion and Control at the same time...good luck.
Peter
There is no doubt that you are correct in your statements on cylinder velocity calculations. There are no arguments.
As I see it, this forum is about giving free advice and “tips”. The folks that ask questions about fluid power don’t really have much of a clue about what they are doing...
Peter likes to unload ALL of the information in one go. He is not wrong, I just prefer to overlook the fact that a vacuum will exist in the head of the cylinder and where I say cylinder velocity is Q/A - that is not wrong either. It is the steady state velocity once the cylinder has been...
You would be better off having a pressure switch on the rod end of the cylinder. Use it to sense the pressure in the rod and when the pressure in the rod end drops off, unload the big pump.
If there is a risk of breaking the workpiece, I would suggest changing PPR3 to a proportional pressure...
What I mean is that spool valves leak. The flow control valve will stop it falling under gravity, but it will creep down as oil leaks over the spool. This may not be a problem for you, but don’t expect the press to stay up, it won’t.
Your plan to measure the rod side pressure to control the...
You need to consider what gravity will do to your press if the rod side is open to tank. It will drop like a stone. You also cannot rely on the directional control valve to hold the press up. You would therefore need a motion control valve of some sort to hold the press up.
During the down...
You don’t need a servo valve for this application. You would only use a servo valve if you want fast response and a high degree of accuracy. Even the pressure setting is not highly accurate if you can live with +/-5%
Using a pressure reducer or a relief valve is dependent on what other...
Google Parker 4300 catalogue. You will find what you need in the adapters section.
You don’t need to buy them from Parker, but this catalogue will give you a visual reference and part numbers for what you need.
If you start with Parker Hannifin, you'll be there all day. Such is the scale of the product base. There are just too many.
There are many types of SAE flanges, what sort do you want?
NPT, JIC, BSP, ORFS, Butt weld, Socket weld...
Identify the size of the flange by the hole centre dimensions...
The ultimate standard, that is the one that cleanliness levels of components are set to achieve, is ISO 4406. The level of cleanliness of the system, under 4406 is measured as the number of 4,6 and 14 micron particles per ml of fluid.
Part cleanliness, including tube and hose, is measured in...
Flow does NOT make it go...
I hate it when people say that.
None of us want to write a story. This is on the basis that most OP’s don’t read or respond to our free help.
I agree with all your points, except where you misunderstand my point and say that I am so wrong.
Whack a mole is a very...
So wrong?
Is it not the case that for a motor of given displacement in CC/rev, it will rotate at a particular speed, dependent on the flow of oil into the said motor at a rate of cubic metres/sec? Less any losses for volumetric efficiency...
Speed determines flow? Are you sure Peter? Is...
The flow determines the speed.
The displacement x pressure (plus some math) determines the torque.
Selecting 5 flow divider elements that have the same displacements as the motors will keep them all at the same speed.
For a given torque requirement, select the appropriate motor for the...
