Megger BITE3 reads "Out of range" when measuring cell and strap impedance. Cell voltage readings are within range 12-13vdc. The strap connectors are not solid bus bar, rather the standard battery cables in parallel (2) per post. How do I resolve the "Out of Range" issue? All (40) batteries are...
Greetings,
I am currently in the preliminary phase of putting together a cbattery testing equipmetomprehensive Preventative Maintenance program to support a large quantity of VRLA 100A33 1600ah batteries. I need recommendations OR comparisons on the following types of equipment:
Megger BITE 3...
Customer has approximately (15) small "CONEX" lockers scattered on a paved lot. Each of these small storage containers have various types of commercial/industrial hazardous waste materials inside (ballasts, fluorescent lamps, empty spray paint cans, batteries, etc.} A few of these metal...
I have recently been assigned to a local manufacturing company that is purchasing European milling machines which are designed to operate at 230/400v 50hz. One of these machines control system is designed (and wired) for 230v (L1-N). The company has wired it up for 3-phase 208 and although the...
Thank you dpc.
Is there any language in NFPA 70E, IEEE 1584 or OSHA that requires employers to electrically and/or mechanically "test" their OCPD's?
Tom
The manufacturing facility where I am employed as an electrician has never had an "Electrical Hazard Assessment, Arc Flash Analysis/Survey, or any ANSI/NETA MTS tesing performed on any of it's electrical distribution or protective relay equipment. Most (if not all) of the electrical equipment...
