sdz - if you read the preface for the 2012 commentary you will see it mentions to delete the wording "for the minimum size of member" of clause 9.1.4.
It was changed to reflect the intentions of the original panel I believe (I found a publication stating this but cant for the life of me...
Its been too long since I took a look at dynamics from first principles (due for a refresher), but I can remember solving eigenvalues using Sturm's method. I have attached my algorithm from my university days which is implemented in Matlab. I can email m file if it is more helpful. I believe...
If the outer supports act as vertical supports only, with tension throughout the entire length of the top flange, I would treat the outer segment as a cantilever with the outside support considered as a load at or below the shear centre of the section:
alpha_m = 1.25 -> 2.25 [Table 5.6.2]
kt =...
KootK,
Interesting point you make there. I would appreciate any references you might be able to point me towards. All the angle cross bracing sets in large industrial structures I have reviewed used tension-only members in their models.
What happens if you analyze only the member that is in tension and neglect the compression member? I typically neglect the compression member in bracing sets comprised of slender members such as angles. In saying that, you need to ensure you treat the members as "tension only" in your analysis...
Another extract from AS1170.2 (see attached), however this time for rectangular prisms.
For an aspect ratio of 2:1, I calculate a Cd of 2.78/1.6 depending on wind direction.
Regards Jake...
medeek - nice calcs on your website. Very impressive.
For what it is worth, I have found the avoiding vlookup functions in your spreadsheets greatly improves their accuracy since they rely on the data being sorted. Instead, use index(XXX,match(XXX,XXX,0)) which will work regardless of the data...
asixth, jayrod12, thank you for your comments. The 20-30 kPa in my previous post for undrained shear strength did not have any FOS applied so will correlate roughly with the 10 kPa shaft adhesion that you mentioned.
For residential footings, Australian Standard AS2870 Clause G5.3 states "No...
Inspired by a recent post on this board, I would like to ask for some more opinions regarding "post/pole" and bored pier footings.
In my location (Queensland, Australia) it is common to see houses and portal frame buildings supported on shallow pier footings. Mostly the soils I deal with are...
Assuming these are analogous to "post footings" typically used in Australia where steel posts are cast into bored piers to support residential construction (i.e. clad frame buildings elevated above ground level) I will share what I have found from my research:
1) cantilever action can be relied...
Indeed it is an interesting subject - one which I don't yet fully grasp to be honest.
I remember deriving the shear forces, axial force and bending moment equations for a catenary shaped beam in university and had a few big 'aha' moments when it all came together. I suspect the same would occur...
@Zaes1980: pygal looks nice. I will keep that one in mind to for next time and might see how well it plays with pyqt.
@RFreund: I gained a lot of good insight into python programming during my university days where I took an introductory course. I did get started with Python before I had any...
