Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Recent content by KSMTNBKR

  1. KSMTNBKR

    When to use bearing factor?

    I'm looking for some guidance on when to use the bearing factor that is presented in MIL-HDBK-516C, Section 5.3.3.f (copied below). MIL-HDBK-516c, Section 5.3.3.f: The design stress values for bolted joints with clearance (free fit) that are subjected to relative rotation under limit load or...
  2. KSMTNBKR

    Material Allowables Question

    I want to use 4140 Steel Plate per ASTM A829, but I can't find strength allowables (Ftu, Fty, Fsu, all that good stuff) for this spec. I do have material allowables for a different spec, which are MMPDS allowables for AMS 6395. But I'm not sure if these allowables apply to ASTM A829. My...
See more

Part and Inventory Search

Back
Top Bottom